N/A

Recessed housing is constructed of 18 gauge galvanized steel. All electronics, including the battery, when applicable, are mounted and prewired in the housing allowing for complete wiring prior to the installation of the panel/trim assembly. The electronics are mounted on a removable sub-chassis to facilitate mounting and maintenance. The recessed housing is provided with vertically adjustable mounting bars allowing for a proper flush ceiling fit. 1/2" conduit knockouts are included on both sides as well as on top of the housing. Surface mounted units utilize a one piece, tapered, brushed aluminum extrusion. Surface housings can be mounted back wall, end wall, ceiling, or pendant. Consult factory.

N/A Led Illuminator:
The LED illuminator consists of 10 Ultra bright Piranha LEDs. The Piranha LED has a nearly 180 degree emitting angle allowing for even illumination. The LEDs are wired in sets of two, insuring in the unlikely event of a single LED failure, the sign will continue to be illuminated.
Trim/Panel Assembly:
The Trim/Panel assembly consists of die formed clear acrylic panel assembly attached to an extruded aluminum trim plate. The panel assembly consists of two panel halves ultrasonically welded together, no hardware is visible. The Trim/Panel is attached to the housing using invisible torsion springs, no hard ware is visible. The "EXIT" letters are silk screened onto the acrylic, using a LED frequency matched paint. Each letter is outlined with a 1/8" groove. The standard trim finish is Brushed Aluminum, bright dipped to stop noticeable finger prints. Other trim finishes are available, see ordering chart below.
Approvals/Warranty:
UL924 listed, Life safety NFPA 101, NEC/OSHA, New York City approved. LED illuminator warranted for 25 years, charger covered by 5 year warranty, NiCad batteries covered by 10 year warranty, 3 years complete, 7 years prorated.

N/A Charge Mode (Fully Discharged Battery)